Designed for use in a variety of applications in the
fixed installation market, where sonic quality and reliability are the
highest priorities, the high performance T500 (250W/channel into 4 ohms)
has been designed with complementary AB bipolar outputs, using the unique
MC2 current driven floating drive stage and conventional analogue level
controls.
The sound quality is maintained over a very wide range of load and temperature
conditions. Sophisticated 'side chain' limiters prevent distortion and
speaker damage but are out-of-circuit until the onset of clipping. The
control circuitry provides full protection against short circuits, DC
and excessive temperature together with inrush current limiting and
delayed 'turn on'.
- Complementary class A/B bipolar outputs, using the unique MC2 current
driven floating drive stage, which gives one of the ‘cleanest’ sounds
available.
- Sophisticated monitoring of amplifier temperature and load conditions.
- Proprietary control and protection circuitry continuously checks
for all fault conditions such as shorted outputs, DC on outputs, excessive
temperature (blocked air flow), component failure etc… and disconnects
the outputs, if such an event occurs.
- Low noise vari-speed fans.
- ‘Side-chain’ clip limiter prevents speaker damage from clipped signals
but only comes into the signal path during limiting, and is inaudible
during normal operation.
- Audio ‘fade-up’ on Power-on.
- Optional internal crossover cards available.
- New proprietary ‘Ultra Cool’ heatsink.
- Full mains inrush protection.
|
- Connectors
Inputs: XLR 3 pin
Outputs: 4 pole SPEAKON
- Rear Panel:
1 x Stereo/bridged mono switch
- Front Panel:
2 x level controls
1 x power on/off switch
- Indicators:
1 x power, 2 x limit, 2 x signal present
1 x auto protect, 1 x bridged
- 8 ohms @ 1kHz: 610
4 ohms @ 1kHz: 1000
2 ohms @ 1kHz: 1500
- Mono Bridged:
8 ohms @ 1kHz: 2000
4 ohms @ 1kHz: 3000
- THD @ Rated Power 4 ohms
1 kHz: < 0.008%
20Hz - 20kHz: < 0.03%
- Input CMRR: > 90 dB
- Hum & Noise: -105 dB
- Gain: +32dB
- Sensitivity for rated output, 4 ohms: +7dBu(1.75mV)
- Damping Factor 1 kHz, 8 ohms: > 400
- Frequency Response: 20Hz-20kHz +0/-0.5dB
- Input Impedance(actively balanced): 20k ohms
- Dimensions - 2U(mm): 88 x 482 x 428
- Weight: 25kg
- Power Requirement:
230 VAC @ 15 amps max
115 VAC @ 30 amps max
|
